PowerBox Royal SRS z wbudowanym iGyro bez GPS


Nr katalogowy: 4720 ·

2935.80PLN

Dane techniczne:

  • Integral iGyro: triple-axis gyro system with heading function and set-up assistant
  • Six independent gyro outputs for: 2 x ailerons, 2 x elevators, 2 x rudders
  • GPS-regulated gyro gain
  • Special regulatory algorithm for fixed-wing model aircraft
  • Extremely accurate triple-axis MEMS sensor
  • Integral Delta and V-tail mixer
  • Door sequencer: six freely programmable outputs with set-up assistant
  • PowerBus: 2 outputs, 16 + 2 channels, compatible with other servo bus systems
  • Servo-Match function: servo centre, end-points and reverse for all 24 servo outputs
  • SRS: Serial Receiver System provides the facility to use receivers with serial interface: Futaba S-Bus, Spektrum DSM2 und DSMX, Jeti, Multiplex M-Link, , HoTT and JR X-BUS
  • Unrestricted channel assignment for all 24 PowerBox outputs
  • Graphic LCD screen with 128 x 64 pixels
  • Extremely user-friendly menu-based programming using the SensorSwitch
  • Up to 18 channels - depending on the radio control system in use
  • Signal amplification and interference suppression for all 24 outputs
  • Flight recorder, recording of lost frames, fail-safe events and all battery data
  • Variable frame rate, range 9ms – 21ms
  • Two 16-bit processors for fast, high-resolution signal processing
  • 2 x double-regulated output voltages for receivers and servos
  • 2 regulated voltage ranges with independent selection facility, 5.9V or 7.4V
  • Connection facilities for Futaba, Jeti, Spektrum, HoTT and Multiplex MSB downlink bus systems
  • Direct transmission of all battery informations, receiver data and GPS data to the transmitter
  • Separate voltage and capacity display for each battery
  • Minimum value memory alerts the user to voltage collapses
  • Large-area heat-sinks for high regulator performance
  • Regulator monitoring, regulator error indicator
  • Support for three battery types: LiPo, NiMH / NiCd, LiFePo
  • Suppression of any servo feedback currents which may occur
  • Updateable with PowerBox Systems USB Interface connectors
 

Technical Data

Operating voltage 4.0V - 9.0V
Power supply 2S LiPo, 2S LiFePo, 5S NiCd/NiMH
Current drain Power-on state 185mA (with LCD)
Current drain Standby 30µA
Maximum load current Peak 4x20A
Drop-out voltage 0.3V
Output voltage 5.9V and/or 7.4V regulated
Signal input serial
Supported RC systems Spektrum, Futaba, HoTT, M-Link, Jeti, JR
Receiver redundancy SRS
Channels 18
Servo sockets 24
Programmable servo outputs 24
Servo signal resolution 0.5µs
Signal frame rate 9ms, 12ms, 15ms, 18ms, 21ms
Integral gyro system iGyro
Gyro regulation Heading- and Normalmode
Gyro sensor type MEMS
Number of sensor axes 3
Screen LCD, backlite
Integral door sequencer yes
Supported telemetry systems Futaba, Jeti, Spektrum, HoTT, M-Link
Dimensions 136 x 82 x 20 mm
Weight 160g
Weight Sensor Switch 15g
Weight of LCD screen 65g
Temperature range -30°C bis +75°C
25518_4720.png 25519_4720 1.png 25520_4720 2.png